SD Part B Supporting Statement 11-22-2019 CLEAN

EDICS Tracking and OMB Number: (XXXX) XXXX-XXXX

Revised: XX/XX/XXXX

RIN Number: XXXX-XXXX (if applicable)

SUPPORTING STATEMENT

FOR PAPERWORK REDUCTION ACT SUBMISSION

EDICS Tracking and OMB Number: (XXXX) XXXX-XXXX

Revised XX/XX/XXXX

RIN Number: XXXX-XXXX (if applicable)

B. Collection of Information Employing Statistical Methods

The agency should be prepared to justify its decision not to use statistical methods in any case where such methods might reduce burden or improve accuracy of results. The following documentation should be provided with the Supporting Statement Part A to the extent that it applies to the methods proposed. For further information, please consult OMB’s Standards and Guidelines for Statistical Surveys.

1. Describe the potential respondent universe (including a numerical estimate) and any sampling or other respondent selection method to be used. Data on the number of entities (e.g., establishments, state and local government units, households, or persons) in the universe covered by the collection and in the corresponding sample are to be provided in tabular form for the universe as a whole and for each of the strata in the proposed sample. Indicate expected response rates for the proposed sample. Indicate expected response rates for the collection as a whole. If the collection had been conducted previously, include the actual response rate achieved during the last collection.

The primary universe of interest for OSERS consists of State Education Agencies. The Survey will not apply to outlying agencies or freely associated States. There are 50 respondents.

2. Describe the procedures for the collection of information, including:

• Statistical methodology for stratification and sample selection.

• Estimation procedure.

• Degree of accuracy needed for the purpose described in the justification.

• Unusual problems requiring specialized sampling procedures, and

• Any use of periodic (less frequent than annual) data collection cycles to reduce burden.

There is no sampling or estimation done for this collection.

3. Describe methods to maximize response and to deal with issues of non-response. The accuracy and reliability of information collected must be shown to be adequate for intended uses. For collections based on sampling, a special justification must be provided for any collection that will not yield “reliable” data that can be generalized to the universe studied.

This is a voluntary survey. Respondents will be notified through:

• Publication in the Federal Register

• Discussions with States and OSEP funded TA providers

• OSEP Summer Conference (July 2019)

• OSERS email and similar electronic notifications.

4. Describe any tests of procedures or methods to be undertaken. Testing is encouraged as an effective means of refining collections of information to minimize burden and improve utility. Tests must be approved if they call for answers to identical questions from 10 or more respondents. A proposed test or set of tests may be submitted for approval separately or in combination with the main collection of information.

There are no statistical procedures or methods utilized by OSEP.

5. Provide the name and telephone number of individuals consulted on statistical aspects of the design and the name of the agency unit, contractor(s), grantee(s), or other persons who will actually collect and/or analyze the information for the agency.

There are no statistical methodologies included in the collection of this information. ED OGC was involved in the development of the instrument. Respondent comments will be collected and reviewed by OSERS/OAS staff.