Section 95.1215 Disclosure policies and Section 95.1217 Labeling requirements

[Code of Federal Regulations]
[Title 47, Volume 5]
[Revised as of October 1, 2005]
From the U.S. Government Printing Office via GPO Access
[CITE: 47CFR95.1217]

[Page 563]

TITLE 47--TELECOMMUNICATION

CHAPTER I--FEDERAL COMMUNICATIONS
COMMISSION (CONTINUED)

PART 95_PERSONAL RADIO SERVICES--Table of Contents

Subpart I_Medical Implant Communications (MICS)

Sec. 95.1217 Labeling requirements.

(a) Medical implant programmer/controller transmitters shall be
labeled as provided in part 2 of this chapter and shall bear the
following statement in a conspicuous location on the device:
This device may not interfere with stations operating in the
400.150-406.000 MHz band in the Meteorological Aids, Meteorological
Satellite, and Earth Exploration Satellite Services and must accept any
interference received, including interference that may cause undesired
operation.
(b) Where a medical implant programmer/control transmitter is
constructed in two or more sections connected by wire and marketed
together, the statement specified in this section is required to be
affixed only to the main control unit.
(c) Medical implant transmitters shall be identified with a serial
number. The FCC ID number associated with the transmitter and the
information required by Sec. 2.925 of the FCC Rules may be placed in
the instruction manual for the transmitter and on the shipping container
for the transmitter, in lieu of being placed directly on the
transmitter.